Dpgt750ec1pl manual

It is only to be used along with the service manual not as a replacement for it as it applies to the appliance type, not the specific model and will go into more details on repairing the appliance. Service Manuals generally provide information and instructions pertaining to product disassembly, schematic diagrams, parts lists, exploded views, troubleshooting guides, wiring diagrams, and much, much more.

Not all appliances and electronics have Tech Sheets or Fast Track publications. Training Manuals generally contain more in-depth servicing information and circuit explanations. Not all appliances and electronics have Training Manuals. Supplements usually address changes in circuitry. To remove the top cover: 1. Remove the Backsplash 2. Remove the 2 screws that hold the box in place. Wear Kevlar gloves or equivalent protection. The dryer drum is made of stainless steel and has three replaceable drum baffles attached to the inside.

The drum rotates clockwise at 47 to 50 rpm. To remove the drum: 1. Two on the front drum support and two on the rear drum support.

The drum roller comes as a complete assembly. To remove the drum rollers: 1. Remove the Top Cover Front Panel 2. It is switched on the neutral side by the door switch. Page 28 5. Remove the 2 Phillips head screws that hold the blower guard in place. Remove the blower guard. Remove the 13 mm center nut. Turn clockwise to remove. Remove the blower wheel. Remove the 3 Phillips head screws from the center of the blower housing. One is fixed at watts and cycles on and off.

The other is variable, controlled by a Triac that varies the wattage from 0 to watts. Page Inlet Thermistor Inlet Thermistor The inlet thermistor is located on the inside of the inlet air duct on both electric and gas models.

Page Hi-Limit Thermostat Hi-Limit Thermostat The hi-limit thermostat is located on the left side of the heater housing on electric models. It is located on the right, upper side of the combustion chamber on gas models.

The most accurate diagnostic check is to measure resistance of the solenoid coils. Page Overview Overview The dryer control has a field service mode that can be accessed by the service technician in order to give critical information on the status of various components of the dryer. This mode will aid the service technician in quickly identifying failed or improper operation of components and systems.

Page 36 Follow the on- screen instructions. Page 37 2. Press the HELP pad. The main help screen is displayed. One of the following screens will be displayed. Vertical lines on the LCD display when the dryer is turned on. Drum out of round Drum felt glue on roller path Loose parts. Page Error Charts Error Charts — 43 — Page 44 — 44 — Page 45 — 45 — Caution: Label all wires prior to disconnection.

Wiring errors can cause improper and dangerous operation. Verify operation after servicing. Page 49 Electric Model — 49 — Page 50 Electric Model — 50 — Page 53 Gas Model — 53 — Page 54 Gas Model — 54 — Page 55 Gas Model — 55 — Due to utility configurations or customer preferences, the door can be set up to open from the right by reversing the door swing.

Page 59 9. Install the handle on the opposite side of the door. Rear of Door Remove the hinges from the door and install them on the opposite side with the hinge pin toward the outside of the door. Opposite Side of Door Page Switching The Washer And Dryer Backsplashes Switching the Washer and Dryer Backsplashes Overview When viewed from the front, the washer is shipped for installation on the left and the dryer is shipped for installation on the right.

If the hose utility connections are arranged so that the units must be installed with the washer on the right and the dryer on the left, the backsplashes of the washer and dryer can be switched in order to Page 61 5.

Disconnect the ribbon at the right of the washer control board by pulling the connector at the end of the ribbon off the metal pins.